[HamWAN PSDR] setting a Dynadish 5 as a dhcp client on wlan1 fails
dpk at randomnotes.org
Wed Feb 13 12:11:42 PST 2019
Steve - please send me a direct contact email. You can reach me at
kd7dk at arrl.net or my address on QRZ.
On Wed, Feb 13, 2019 at 12:08 PM Doug Kingston <dpk at randomnotes.org> wrote:
> I can take care of these updates. I'll work with Steve.
> On Wed, Feb 13, 2019 at 12:00 PM Steve - WA7PTM <psdr-list at aberle.net>
>> Is anyone maintaining the
>> web page?
>> The reasons I ask are:
>> • Step 1 will not work as listed as the command is wrong (should be
>> "/system package update install" in RouterOS v6.43.12) and if some
>> preliminary steps are not taken (moving the default network to one
>> connected to the Internet with a "/ip address add address=a.b.c.d/xx
>> interface=ether1" command and establishing a default gateway with a "/ip
>> route add gateway a.b.c.gw" command), then the update will fail.
>> • Step 21 on a Dynadish5 results in a "failure: incompatible band and
>> channel-width" message unless "channel-width=5mhz" is added to the
>> • Step 22 on a Dynadish5 results in a "failure: can not run on slave
>> interface" message.
>> This last one has me stumped, and I have been unable to determine a
>> workaround. Has anyone else encountered and solved this problem?
>> PSDR mailing list
>> PSDR at hamwan.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the PSDR