[HamWAN PSDR] WinBox V3.18 will not log in to two new BaseBox 5 Intl V6.18.

David Haworth davidahaworth at icloud.com
Tue Nov 6 10:22:43 PST 2018

Hi Scott,

Thank you for your offer to help.

Do you know the address of the HamWAN conference this Sat. Nov. 10, 2018 9:00 am to noon in Portland, OR area?

73 David WA9ONY

> On Nov 6, 2018, at 10:16 AM, Scott J. Burrows <sburrows97211 at comcast.net> wrote:
> David, if you are unable to reset the device, bring it to the Digital Meeting.  I have a few possible tricks.  Scott, N7DOD
> ----- Original Message -----
> From: David Haworth via PSDR <psdr at hamwan.org <>>
> Reply-To: David Haworth <davidahaworth at icloud.com <>>, Puget Sound Data Ring <psdr at hamwan.org <>>
> To: Puget Sound Data Ring <psdr at hamwan.org <>>
> Sent: 11/5/2018 8:10:48 AM
> Subject: Re: [HamWAN PSDR] WinBox V3.18 will not log in to two new BaseBox 5 Intl V6.18.
> Hi Dylan
> Thank you for the info on reset.
> I will work on it.
> 73 David WA9ONY
>> On Nov 4, 2018, at 7:51 PM, Dylan Ambauen <dylan at ambauen.com <>> wrote:
>> Sounds frustrating. Last time I did a hardware reset for the BaseBox5, the instructions seemed kinda vague. And, if you hold the reset button down too short or too long, you'll go into a different hardware mode.  And after reset, I could _only_ reconnect with winbox, IIRC there was no ip interface enabled/configured.
>> Don't worry, the hardware is probably not ruined, and if it is, it is probably not your fault. Try double-checking hardware reset instructions again, make sure you're doing it right. I think I tried resetting about 10 times before getting it right.
>> ---
>> Dylan Ambauen
>> On Fri, Nov 2, 2018 at 9:51 AM David Haworth via PSDR <psdr at hamwan.org <>> wrote:
>> WinBox V3.18 will not log in to two new BaseBox 5 Intl V6.18.
>> Login: admin
>> Password:
>> WinBox hangs with message 
>> Logging in...
>> I have reset one of the BaseBox 5 Intl  with no results.
>> I have tried WinBox V3.18, V3.17, V3.16, V3.15, V3.14 and V3.13.
>> BaseBox 5 is connected to an antenna.
>> Using Dell Windows 8.1 laptop with CAT 6A cable connected directly to  BaseBox 5.
>> No router or hub is being used.
>> Using MAC or IP Address has no affect.
>> Board info form WinBox: RB912UAG-5HPnD
>> IE will not connect to <>
>> Both BaseBox 5 make a short funny sound before making the one beep, long delay, two beeps.
>> The beeps are similar to the QRT 5 power on.
>> The QRT 5 does not make the short funny sound.
>> The Dell works fine with a QRT 5 Intl.
>> http://www.stargazing.net/david/sdr/HamWAN.html#P2a <http://www.stargazing.net/david/sdr/HamWAN.html#P2a>
>> What do you recommend to try next to get WinBox to work with the two BaseBox 5.
>> Best Regards
>> David Haworth, WA9ONY
>> _______________________________________________
>> PSDR mailing list
>> PSDR at hamwan.org <>
>> http://mail.hamwan.net/mailman/listinfo/psdr <http://mail.hamwan.net/mailman/listinfo/psdr>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.hamwan.net/pipermail/psdr/attachments/20181106/29956506/attachment.html>

More information about the PSDR mailing list